Electrolux ESF45010 Manuel d'utilisateur Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The wash results are not satisfactory
The dishes are not
clean
The wrong programme has been selected.
The dishes are arranged in such a way as to stop water reaching all parts
of a surface. The baskets must not be overloaded.
The spray arms do not rotate freely due to incorrect arrangement of the
load.
The filters in the base of the washing compartment are dirty or incorrectly
positioned.
Too little or no detergent has been used.
Where there are limescales deposits on the dishes; the salt container is
empty or incorrect level of the water softener has been set.
The drain hose connection is not correct.
The salt container cap is not properly closed.
The dishes are wet
and dull
Rinse aid was not used.
The rinse aid dispenser is empty.
There are streaks,
milky spots or a blu-
ish coating on
glasses and dishes
Decrease rinse aid dosage.
Water drops have
dried onto glasses
and dishes
Increase rinse aid dosage.
The detergent may be the cause. Contact the detergent manufacturer
consumer care line.
If after all these checks, the problem persists,
contact your local Service Force Centre.
Technical data
Dimensions Width
Height
Depth
45 cm
85 cm
63 cm
Electrical connection - Voltage -
Overall power - Fuse
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Water supply pressure Minimum
Maximum
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
Capacity 9 place settings
Testing in accordance with EN 60704 must
be carried out with appliance fully loaded and
using the test programme (see "Consump-
tion values").
Test in accordance with EN 50242 must be
carried out when the salt container and rinse
aid dispenser have been filled with salt and
rinse aid respectively and using the test pro-
gramme (see "Consumption values").
Full load: 9 standard place settings
Amount of detergent required: 5 g + 20 g (Type B)
Rinse aid setting position 4 (Type III)
18 electrolux
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire