Electrolux EDI97170W Manuel d'utilisateur télécharger pdf (Page 25)

INSTALLATION

Appliance positioning

• It is recommended that, for your conven-

ience, the machine is positioned close to

your washing machine.

• The tumble dryer must be installed in a

clean place, where dirt does not build up.

• Air must be able to circulate freely all

round the appliance. Do not obstruct the

front ventilation grille or the air intake

grilles at the back of the machine.

• To keep vibration and noise to a mini-

mum when the dryer is in use, it should

be placed on a firm, level surface.

• Once in its permanent operating position,

check that the dryer is absolutely level

with the aid of a spirit level. If it is not,

raise or lower the feet until it is.

• The feet must never be removed. Do not

restrict the floor clearance through deep-

pile carpets, strips of wood or similar.

This might cause heat built-up which

would interfere with the operation of the

appliance.

Important!

• The hot air emitted by the tumble dryer

can reach temperatures of up to 60°C.

The appliance must therefore not be in-

stalled on floors which are not resistant to

high temperatures.

• When operating the tumble dryer, the

room temperature must not be lower

than +5°C and higher than +35°C, as it

may affect the performance of the appli-

ance.

• Should the appliance be moved, it must

be transported vertically.

• The appliance must not be installed be-

hind the lockable door, a sliding door a

door with a hinge on the opposite side to

that of the appliance in such a way that a

full opening of the dryer is restricted.

Removing transport safety packaging

Caution!

Before use all parts of the transport packag-

ing must be removed.

1. Open loading door

2. Pull off adhesive strips from inside ma-

chine on top of drum.

3. Remove foil hose and polystyrene pad-

ding from the machine.

Drying rack unpacking

Caution! Before appliance use all

packaging parts and drying rack must

be removed from the drum. The inside

of the drum must be clean.

1 2

4 3

To unpack the rack:

1. Remove middle polystyrene part by pull-

ing it.

electrolux 25

1 2 ... 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire