Electrolux EDI97170W Manuel d'utilisateur télécharger pdf (Page 26)

Warning! The manufacturer declines

any responsibility for damage or

injury through failure to comply with

the above safety precautions.

Should the appliance power supply

cable need to be replaced, this must

be carried out by an authorised serv-

ice engineer or a qualified electri-

cian. .

The appliance is supplied with a 13 amp plug

fitted. In the event of having to change the

fuse in the plug supplied, a 13 amp ASTA

approved BS 1363/A fuse must be used.

1

2

3

4

The wires in the mains lead are coloured in

accordance with the following code:

1 Blue - Neutral

2 cord clamp

3 Brown - Live

4 Green and Yellow - Earth

The wire coloured green and yellow must be

connected to the terminal marked with the

letter «E» or by the earth symbol

or col-

oured green and yellow.

The wire coloured blue must be connected

to the terminal «N» or coloured black.

The wire coloured brown must be connected

to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or

stray strands of wire present and the cord

clamp must be secure over the outer sheath.

Warning! A cut off plug inserted into

a 13 amp socket is a serious safety

(shock) hazard.

Ensure that the cut off plug is dis-

posed of safely.

Warning! The plug must be

accessible after installing the

machine.

Permanent connection

In the case of permanent connection it is

necessary that you install a double pole

switch between the appliance and the elec-

tricity supply (mains), with a minimum gap of

3 mm between the switch contacts and of a

type suitable for the required load in compli-

ance with the current electrical regulations.

The switch must not break the yellow and

green earth cable at any point.

Changing door stop

Warning! Before changing the door

stop, disconnect the mains plug.

1. Open loading door.

2.

Unscrew hinge A from the front of the

machine and take off the loading door.

3. Remove cover plates B . To do this, in-

sert a thin screwdriver into the slots as

shown in the illustration, press down-

wards slightly and pry out the cover

plates.

AC

C

D

A

B

4. Use an appropriate tool and exert pres-

sure to unfasten locking block C from the

snap-on fixture, take out and re-insert on

the other side having rotated the block

through 180°.

26 electrolux

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

Commentaires sur ces manuels

Pas de commentaire