Electrolux EDI97170W Manuel d'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
BUZZER permanent off 1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS and DELICATE buttons
and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use BUZZER button
to activate or deactivate sound but machine does not memorize
your selection.
Water hardness
Water contains, a variable
quantity of limestone and min-
eral salts of which quantities
vary according to geographical
locations thus varying its con-
ductivity values.
Relevant variations of the con-
ductivity of the water compared
to those prefixed by the factory
could slightly influence the re-
sidual humidity of the laundry at
the end of the cycle. Your dryer
allows you to regulate the sen-
sitivity of the drying sensor
based on conductivity values of
the water.
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE and START/PAUSE but-
tons and hold down for approx. 5 seconds. The current setting
is on the display:
low conductivity <300 micro S/cm
medium conductivity 300-600 micro S/cm
high conductivity >600 micro S/cm
3. Press the START/PAUSE button sequentially until you set de-
sired level.
4. To memorize setting press simultaneously the the DELICATE
and START/PAUSE buttons or turn knob to O OFF position
Hints for test institutes
Parameters possible to checked by the Test
Institutes:
Energy consumption (corrected with final
humidity) during the cupboard dry cotton
cycle with nominal load.
Energy consumption (corrected with final
humidity) during the cupboard dry cotton
cycle with half load.
Final humidity (during cupboard dry cot-
ton, iron dry cotton and cupboard dry easy
care)
Condensation efficiency (corrected with fi-
nal humidity) during cupboard dry cotton
cycle with nominal and half load
All the cycles have to be checked in accord-
ance with EN 61121 (Tumble dryers for
household use – Methods for measuring the
performance).
Installation
Appliance positioning
It is recommended that, for your conven-
ience, the machine is positioned close to
your washing machine.
The tumble dryer must be installed in a
clean place, where dirt does not build up.
Air must be able to circulate freely all round
the appliance. Do not obstruct the front
ventilation grille or the air intake grilles at
the back of the machine.
To keep vibration and noise to a minimum
when the dryer is in use, it should be
placed on a firm, level surface.
Once in its permanent operating position,
check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or
lower the feet until it is.
The feet must never be removed. Do not
restrict the floor clearance through deep-
pile carpets, strips of wood or similar. This
might cause heat built-up which would in-
terfere with the operation of the appliance.
24 electrolux
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire