Electrolux EDI97170W Manuel d'utilisateur télécharger pdf (Page 20)

1. Open door.

2. Open door in plinth. To do this, press the

release button on the bottom of the door

aperture and open the door in the plinth

to the left.

3. Clean fluff from the inside of the door and

the heat exchanger front chamber. Wipe

the door seal with a damp cloth.

4. Turn both lock washers inwards.

5. Use the handle to pull the heat exchanger

out of the base and carry it horizontally to

prevent any remaining water from spilling.

6. To empty the heat exchanger, hold verti-

cally over a washing-up bowl.

Caution! Do not use sharp objects to

clean. The heat exchanger could

develop leaks.

7. Clean heat exchanger.

It is best to use a brush or to rinse thor-

oughly with a hand-held shower.

8. Replace heat exchanger and lock into

place (turn both lock washers outwards

until they snap into place).

9. Close door in plinth.

The appliance will not operate if the

HEAT EXCHANGER indicator is still lit.

Caution! Never operate the dryer

without the heat exchanger.

Cleaning the drum

Caution! Do not use abrasives or steel

wool to clean the drum.

Lime in the water or cleaning agents may

form a barely visible lining on the inside

of the drum. The degree to which the

laundry has been dried is then no longer

detected reliably. The laundry is damper

than expected when removed from the

appliance.

Use a standard domestic cleaner (e.g. vine-

gar-based cleaner) to wipe down the inside

of the drum and drum ribs.

Clean control panel and housing

Caution! Do not use furniture cleaners

or aggressive cleaning agents to clean

the machine.

Use a damp cloth to wipe down the control

panel and housing.

20 electrolux

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Commentaires sur ces manuels

Pas de commentaire