LAVAMAT 60840 L - 62840 LUser manual Washing Machine
2. If required, pour fabric softener into thecompartment marked (the amountused must not exceed the MAX mark inthe drawer).Close the drawer gently.Se
Select the SPIN speed or the RINSE HOLD option (Button 3)When the required programme has been selected, your appliance automatically proposesthe maxim
Select the START/PAUSE (Button 8)To start the selected programme, press the button 8 , the corresponding red pilot light stopsblinking.The pilot light
Altering an option or a running programmeIt is possible to change any option before the programme carries it out. Before you makeany change, you must
Stand by : once the programme has finished after a few minutes the energy saving systemwill be enabled. The brightness of the display is reduced. By p
Detergents and additivesGood washing results also depend on the choice of detergent and use of the correct quan-tities to avoid waste and protect the
Washing programmesProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentCOTTONS/LINEN
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentEASY IRON60°- ColdMain wash - R
ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSPINDrain and long spinMax. loa
cording to the softening powder manufacturer's instructions. This will help to prevent theformation of lime deposits.After each washLeave the doo
Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstruction manual
Do not clean the drum with acidic descaling agents, scouring agents containing chlorineor iron or steel wool.1. Remove any rust deposits on the drum w
6. Pull out the emergency emptying hose,place it in the container and remove itscap.7. When no more water comes out, un-screw the pump cover by turnin
Never remove the pump cover during a wash cycle, always wait until the appliance hasfinished the cycle, and is empty. When refitting the pump cover, e
7. Screw the hose back to the machine andmake sure the connection is tight.8. Turn on the water tap.Emergency emptying outIf the water is not discharg
What to do if…Certain problems are due to lack of simple maintenance or oversights, which can be solvedeasily without calling out an engineer. Before
Problem Possible cause/SolutionThe machine does not empty and/or does notspin:The drain hose is squashed or kinked. • Check the drain hose connection.
Problem Possible cause/SolutionThe machine vibrates or is noisy:The transit bolts and packing have not been re-moved.• Check the correct installation
Technical dataDimensions WidthHeightDepth60 cm85 cm63 cmElectrical connection Information on the electrical connection is given on the ratingplate, on
1. After removing all the packaging, careful-ly lay machine on it’s back to remove thepolystyrene base from the bottom.2. Remove the power supply cabl
4. Slide out the relevant plastic spacers.5. Open the porthole, take out the inlet hosefrom the drum and remove the polystyr-ene block fitted on the d
Environment concerns 33Packaging materials 33Ecological hints 33Subject to change without noticeOperating instructions Safety informationRead
Positioning and levellingInstall the machine on a flat hard floor.Make sure that air circulation around the machineis not impeded by carpets, rugs etc
3. Set the hose correctly by loosening thering nut. After positioning the inlet hose,be sure to tighten the ring nut again toprevent leaks.4. Connect
This could be done by tying it to the tapwith a piece of string or attaching it to thewall.2.In a sink drain pipe branch. This branchmust be above the
WARNING!Should the appliance power supply cable need to be replaced, this must be carriedout by a Service Centre.Environment concernsThe symbol on
34
35
www.electrolux.com132951561-00-122010
Installation• This appliance is heavy. Care should be taken when moving it.• When unpacking the appliance, check that it is not damaged. If in doubt,
• Make sure that children or pets do not climbinto the drum. To prevent children or petsbecoming trapped inside the drum the ma-chine incorporates a s
5 Drain pump6 Adjustable feetDetergent dispenser drawer Compartment for detergent used for pre-wash . The prewash detergent is added at the be-ginning
7 DISPLAY8 START/PAUSE button9 DELAY START button10 Indicator pilot lightsSymbols : Rinse Hold, ColdDisplay7.27.37.1Duration of selected programme
Child safety lock (7.3)Indicator pilot lights (10)After having pressed the button 8 , the WASHINGpilot light ( 10.1 ) comes on.When the pilot light 10
•Before pressing button 8 : it will be impossible to start the machine.•after pressing button 8 : it will be impossible to change any other programme
Commentaires sur ces manuels