Electrolux EI24WC75HS Manuel d'utilisateur télécharger pdf (Page 7)

Door Handle Mounting Instructions

Ensure Handle Set Screws

are Facing to the outside

edge of door.

Lower End Cap

Upper End Cap

Installation

NOTE

All set screws should be tightened and sub-ﬂush (Allen set screw should be seated just below the surface of

the end cap) of handle end cap. The end caps should be drawn tight against the door with no gaps.

1 Remove handle from carton and any other protective packaging.

2 Position handle end caps over upper and lower pre-installed

shoulder bolts (A) that are fastened into door, ensuring the holes

for the set screws are facing towards the outside edge of the door.

3 While holding handle ﬁrmly against door, fasten upper and lower

Allen set screws (B) with supplied Allen wrench.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Electrolux EI24WC75HS Manuel d'utilisateur Page 7