Electrolux E40PV100FS Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Ventilateurs Electrolux E40PV100FS. Electrolux E40PV100FS User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Installation
INSTALLATION PLANNING
A qualified installer must complete the installation of this built-in appliance. Proper
installation is your responsibility.
Carefully check the location where the hood is to be installed. The hood should be
placed for convenient access. Make certain that electrical power can be provided
in the selected location.
Plan the installation so that all minimum clearances are met or exceeded.
Dimensions shown provide minimum clearances, unless otherwise noted.
Make certain that you have everything necessary to ensure a proper
installation before proceeding.
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Installation

InstallationINSTALLATION PLANNINGA qualified installer must complete the installation of this built-in appliance. Proper installation is your responsib

Page 2 - Installation

InstallationVERIFY PACKAGE CONTENTS Unpack hood and check contents.You should receive:1 - Hood1 - Decorative Flue Assembly1 - Support Frame 1 - Duct

Page 3

InstallationINSTALLING THE DUCTWORK1 Decide where the ductwork will run between the hood and the outside. Figure 5.2 A straight, short duct run will

Page 4

InstallationINSTALLING THE SUPPORT SYSTEM1 At hood location, install 2 x 4 cross framing between ceiling joists using dimensions shown in Figure 6.2

Page 5

InstallationCONNECTING THE DECORATIVE FLUE1 Secure the upper flue to the upper support frame with the mounting screws (3.9 x 9.5mm).2 Insert the lowe

Page 6

InstallationMOUNTING THE HOOD TO SUPPORT FRAME1 Insert four (4) bolts through the top of the hood from the inside.2 Use four (4) nuts and four (4) wa

Page 7

InstallationCONNECTING THE DUCTWORK1 Use 8” round metal duct to connect the discharge collar on the hood to the ductwork above.2 Use duct tape to ma

Page 8 - INSTALLING THE FILTER(S)

INSTALLING THE FILTER(S)1 To remove the grease filter, grip the latch and pull it down. This will disengage the filters from the hood. Tilt the filter d

Commentaires sur ces manuels

Pas de commentaire