
1 To ensure adequate ventilation for your refrigerator, it
is recommended to provide space of 60mm on both
sides and at the back, and space of 90mm above the
refrigerator. Insufficient spacing will decrease cooling
efficiency, increase energy consumption and may reduce
the life of the unit (see page 3).
2 Using the two front adjustable feet, ensure that the
refrigerator is positioned firmly and level on the floor.
3 Using the adjustable feet, raise the front of the unit so it
leans back slightly, this will assist in door closing. Make
nal adjustments to ensure that the doors are correctly
aligned.
4 Remove the 4 screws from the bottom of the refrigerator
and use these to fit the kickplate (supplied inside the
refrigerator compartment).
5 Connect the power plug to a 240 volt 10 amp power
point.
NOTES:
• Positionyourrefrigeratorsothattheplugisaccessible.
• Keepyourrefrigeratoroutofdirectsunlight.
• Donotplacenexttoaheatgeneratingappliance.
• Thisrefrigeratorisdesignedforindooruseonly–donot
placetheunitonanunsealedsurface.
• Toavoidvibrationandmisalignmentofthedoors,theunit
mustbelevel.Placetheunitonasolidatsurface.Uneven
oorseg.slate,tilesandoorboards,cancausetheunitto
sagovertimecausingthedoorstobecomemisaligned.
• Ifthemainspowerisswitchedonwhenthedoorisopen,
thedooralarmwillsound.Closethedoortostopthealarm.
Installation
2 installation electrolux four-door refrigerator
Whentransporting
• Using the rollers, it is possible to move back and forth.
Carry the refrigerator by holding the holding devices
located on the rear and bottom.
Before using your refrigerator
• Clean the inside parts with a cloth soaked in warm
water. If soapy water is used, wipe it off thoroughly.
door is raised
door is raised
Lower the foot
at right side*
Lower the foot
at left side*
*Until the adjustable foot on the
other side is slightly off ground.
Adjustable feet
Screw
(4 screws)
Screw
Kickplate
electrolux four-door refrigerator dimensions/clearances/technical data 3
Dimensions
890mm
890mm
685mm
13mm
1120mm
817.5mm
441.5mm
876.5mm
727.5mm
1720mm
890mm
890mm
685mm
13mm
1120mm
817.5mm
441.5mm
817.5mm
200mm
12mm
50mm
40mm
Clearances
Recommended clearances
These are the recommended minimum clearances.
NOTE:
Doorsaredesignedtositproudofcabinetry(notush).
Theclearancesshownabovearetherecommended
minimumclearances.Foroptimumproductoperation,it
isrecommendedthattheclearanceattherearshouldnot
exceed75mm.
When positioned in a corner area, spacing of at least
325mm on the sides will allow the doors to open enough
to enable removal of the crisper bins and shelves.
Technical data
Refer to data label on the rear of the appliance for details.
102mm
90mm
60mm
60mm 60mm
Recommended
airspace
CABINET
DOORS
325mm
60mm
60mm 60mm
Recommended
airspace
CABINET
DOORS
890mm
685mm
13mm
1120mm
817.5mm
441.5mm
817.5mm
200mm
12mm
876.5mm
727.5mm
50mm
40mm
90°
102mm
90mm
60mm
60mm 60mm
Recommended
airspace
CABINET
DOORS
325mm
Front face of
bench aligned
to front edge
of cabinet
Commentaires sur ces manuels