Electrolux EGG3322NOX Manuel d'utilisateur télécharger pdf (Page 13)

• from natural gas G20 20 mbar to

liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20

20 mbar, undo the bypass screw

approximately 1/4 of a turn.

WARNING!

Make sure the flame does

not go out when you quickly

turn the knob from the

maximum position to the

minimum position.

8.5 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate

agree with the voltage and the power

of the local power supply.

• This appliance is supplied with a

mains cable. It has to be supplied with

a correct plug which can hold the load

that the rating plate rates. Make sure

that you install the plug in a correct

socket.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the

appliance is in connection with an

extension cable, an adapter or a

multiple connection. Make sure that

the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

Make sure that you connect

the blue neutral cable to the

terminal with a letter "N" on

it. Connect the brown (or

black) phase cable to the

terminal which has a letter

"L". Keep the phase cable

connected at all times.

8.6 Connection cable

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H05V2V2-F T90.

Make sure that the cable section is

applicable to the voltage and the working

temperature. The yellow / green earth

wire must be approximately 2 cm longer

than the brown (or black) phase wire.

8.7 Building In

30 mm

55 mm

40-50 mm

min. 650 mm

490 mm

min. 450 mm

270 mm

A

B

A. supplied seal

B. supplied brackets

CAUTION!

Install the appliance only on

a worktop with flat surface.

8.8 Installation of more than

one hob

If several hobs are to be installed side by

side into the same cut out, an assembly

kit including a support side bracket and

supplementary seals is available at our

Authorised Service Centres. The relevant

installation instructions are supplied

within the kit package.

8.9 Possibilities for insertion

The panel installed below the hob must

be easy to remove and let an easy

access in case a technical assistance

intervention is necessary.

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire