Electrolux EHG90839X Manuel d'utilisateur télécharger pdf (Page 7)

electrolux 7

Operation

Hob burner control knobs

The symbols on the knobs mean:

= no gas supply

= maximum gas supply

= minimum gas supply

For easier lighting, proceed before

putting a pan on the pan support.

Lighting the burners

To light a burner, turn the relevant

knob anticlockwise to maximum

position ( ) and push down the knob

to ignite.

After lighting the flame, keep the

knob pushed down for about 5

seconds. This will allow the

"thermocouple" (Fig - D) to be heated

and the safety device to be switched off,

otherwise the gas supply would be

interrupted. Then, check the flame is

regular and adjust it as required.

If you cannot light the flame even

after several attempts, check the "cap"

(Fig - A) and “crown” (Fig - B) are in

the correct position.

In the absence of electricity, ignition

can occur without the electrical device;

in this case approach the burner with a

flame, push the relevant knob down and

turn it anti-clockwise until it reaches the

"maximum" position.

To switch off burners

To put the flame out, turn the knob to

the symbol ( ).

Take care when frying food in

hot oil or fat, as the overheated

splashes could easily ignite.

)

)

A - Burner cap

B - Burner crown

C - Ignition candle

D - Thermocouple

A

B

C

D

Triple Crown Burner

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Commentaires sur ces manuels

Pas de commentaire