Electrolux EHL6740FOK Manuel d'utilisateur Page 1

EHL6740FOKEN HOB USER MANUAL

The indicator of the cooking zone goesout.Minute MinderYou can use this function as a MinuteMinder when the hob is activated and thecooking zones do n

• Each phase has a maximum electricityloading of 3700 W.• The function divides the powerbetween cooking zones connected tothe same phase.• The functio

timer sounds. The difference in theoperation time depends on the heatsetting level and the length of the cookingoperation.5.5 Examples of cookingappli

• Use a special cleaner applicable for thesurface of the hob.• Use a special scraper for the glass.6.2 Cleaning the hob• Remove immediately: melted pl

Problem Possible cause RemedyResidual heat indicatordoes not come on. The zone is not hot be-cause it operated only for ashort time.If the zone operat

Problem Possible cause Remedy comes on.The electrical connection isincorrect. The supply volt-age is out of range.Speak to a qualified electri-cian to

mains cable type: H05BB-F Tmax90°C.• To replace the damaged mains cableuse the following (or higher) mainscable type: H05BB-F Tmax 90°C.Speak to your

min.12 mmmin. 2 mm 8.5 Protection boxIf you use a protection box (an additionalaccessory), the front airflow space of 2mm and the protective floor dir

9.2 Cooking zones specificationCooking zone Nominal pow-er (maximumheat setting)[W]Power func-tion [W]Power func-tion maximumduration [min]Cookware di

ENGLISH19

CONTENTS1. SAFETY INFORMATION... 32. SAFETY INSTRUCTIONS...

www.electrolux.com/shop867301927-C-282014

1. SAFETY INFORMATIONBefore the installation and use of the appliance, carefullyread the supplied instructions. The manufacturer is notresponsible i

• Metallic objects such as knives, forks, spoons and lidsshould not be placed on the hob surface since they canget hot.• Do not use a steam cleaner to

• Make sure the mains cable or plug (ifapplicable) does not touch the hotappliance or hot cookware, when youconnect the appliance to the nearsockets•

• This appliance is for cooking purposesonly. It must not be used for otherpurposes, for example room heating.2.4 Care and cleaning• Clean regularly t

SensorfieldFunction Comment1STOP+GO To activate and deactivate the function.2- Heat setting display To show the heat setting.3Bridge To activate and d

3.4 OptiHeat Control (3 stepResidual heat indicator)WARNING! / / There is a risk ofburns from residual heat. Theindicator shows the level ofthe re

To deactivate the function: touch /. The cooking zones operateindependently.When you use only one cooking zone ofthe pair we recommend that you use