Electrolux EHS7043K Manuel d'utilisateur télécharger pdf (Page 35)

35

Fitting the hob to the

worktop

Before fitting the hob into the cut out, an

adhesive seal must be fitted to the underside

outside edge of the hob. It is essential that

no gaps are left in this seal in order to

prevent spillage near the hob seeping into

the cabinet below.

Proceed as follows:

1. Remove the pan supports, the burner

caps and crowns and turn the hob upside

down, taking care that the spark plugs

and the thermocouples are not damaged

in this operation.

2. Place the sealing gasket all around the

glass top edge as shown in Fig. 3.

3. Fit the hob in the cut out and push it

down until the glass top and the worktop

make contact, as shown in Fig. 4. The

side springs ensure centering.

"

A) Seal Fig. 4

A

Fig. 3

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41

Commentaires sur ces manuels

Pas de commentaire