Electrolux EHT60410K Manuel d'utilisateur télécharger pdf (Page 9)

• Be very careful when you replace

the pan supports to prevent the hob

top from damage.

After cleaning, dry the appliance with a

soft cloth.

Removing the dirt:

1.

– Remove immediately: melting

plastic, plastic foil, and food con-

taining sugar.

– Stop the appliance and let it

cool down before you clean: lime-

scale rings, water rings, fat stains,

shiny metallic discolorations. Use a

special cleaner applicable for sur-

face of hob.

2.

Clean the appliance with a damp

cloth and some detergent.

3.

At the end rub the appliance dry

with a clean cloth.

WARNING!

Do not use knives, scrapers or

similar instruments to clean the

surface of the glass or between

the rims of the burners and the

frame (if applicable).

WARNING!

Do not slide cookware over the

glass because it could scratch the

surface. Also, do not let hard or

sharp objects fall onto the glass or

hit the edge of the hob.

After cleaning the hob, make sure that the

pan supports are correctly positioned. In

order to properly place the pan supports,

make sure that an arm of the pan support

is positioned in correspondence with the

hole placed at the base of the burner as

shown in the picture. This way, the pan

support will be stable and fixed.

6.1 Cleaning of the spark plug

This feature is obtained through a ceramic

ignition candle with a metal electrode.

Keep these components well clean to

prevent difficult lighting and check that the

burner crown holes are not obstructed.

6.2 Periodic maintenance

Periodically speak your local Service

Force Centre to check the conditions of

the gas supply pipe and the pressure ad-

juster, if fitted.

7. TROUBLESHOOTING

Problem Possible cause Remedy

There is no spark when

lighting the gas

• There is no electrical

supply

• Make sure that the unit

is connected and the

electrical supply is

switched on.

• Control the fuse. If the

fuse is released more

than one time, refer to

a qualified electrician.

• Burner cap and crown

are placed uneven

• Make sure that the

burner cap and crown

are in correct positions.

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire