Electrolux EKK60331X Manuel d'utilisateur télécharger pdf (Page 9)

electrolux 9

The gas burner controls

To light a burner:

1.1.

1.1.

1. push the relevant control knob

in completely and turn it

anticlockwise to the maximum

position ( );

2.2.

2.2.

2. upon ignition, keep the knob

pushed down for about 5

seconds. This will allow the safety

device ("thermocouple" - see

figure 2, letter D) to be heated and

the safety device to be switched

off, otherwise the gas supply

would be interrupted;

3.3.

3.3.

3. then, check the flame is regular

and adjust it as required.

If the burner does not ignite, turn the

control knob to zero, and try again.

If after a few attempts the burner

does not ignite, check that the burner

cap and crown (see figure 2, letter A and

B) are correctly positioned.

To interrupt the supply of gas, turn

the knob in a clockwise direction to the

position " ".

When lighting the hob manually:

Hold a flame near the burner. Never turn

the control knob before approaching the

burner with the flame.

When switching on the mains,

after installation or a power

cut, it is quite normal for the

spark generator to be

activated automatically.

If you use a saucepan which is

smaller than the recommend-

ed size, the flame will spread

beyond the bottom of the pan,

causing the handle to over-

heat.

Fig. 1

!!

!!

!

Fig. 2

A - Burner Cap

B - Burner crown

C -Spark generator

D -Thermocouple

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Commentaires sur ces manuels

Pas de commentaire