Electrolux GK69TSO Manuel d'utilisateur télécharger pdf (Page 14)

8.3 Connection cable

• The hob is supplied with a connection

cable.

• To replace the damaged mains cable

use the following (or higher) mains

cable type: H05VV-F. Speak to your

local Service Centre.

8.4 Electrical connection

Install the hob with a socket supply line. If

there is no socket supply line, the fixed

home electrical system must include an

isolating device with at least a 3 mm-

contact separation to enable a

simultaneous and all-pole cut off from the

mains (according to NIN SEV 1000).

1

2

3

1

2

3

1

2

3

1

2

3

8.5 Attaching the seal to the

rabbet

1. Clean the rabbets in the worktop.

2. Cut the supplied seal stripe into 4

stripes. The stripes must have the

same length as the rabbets.

3. Cut the ends of the stripes at an angle

of 45°. They should fit in the corners

of the rabbets accurately.

4. Attach the stripes to the rabbets. Do

not extend the stripes. Do not bond

ends of stripes one over another.

After you assemble the hob, seal the

remaining gap between glass ceramic and

the worktop with silicone. Make sure the

silicone does not get under the glass

ceramic.

8.6 Attaching the seal

1. Clean the worktop around the cut out

area.

2. Attach the supplied seal stripe to the

lower edge of the hob along the outer

edge of the glass ceramic. Do not

extend it. Make sure that the ends of

the seal stripe are located in the

middle of one side of the hob.

3. Add some mm when you cut the seal

stripe to the length.

4. Push the two ends of seal stripe

together.

www.electrolux.com14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire