Electrolux WAL7E300 Manuel d'utilisateur télécharger pdf (Page 24)

The programme starts, the door is

locked. The display shows the indicator

.

The drain pump can operate

shortly before the appliance

fills water.

10.7 Starting a programme with

the delay start

1. Touch the Delay Start button

repeatedly until the display shows the

desired delay time. The indicator

comes on.

2. Touch the Start/Pause button.

The appliance starts the countdown of

the delay start.

When the countdown is completed, the

programme starts.

The PROSENSE estimation

starts at the end of the

countdown.

Cancelling the delay start after

the countdown has started

To cancel the delay start:

1. Touch the Start/Pause button to

pause the appliance. The related

indicator flashes.

2. Touch the Delay Start button

repeatedly until the display shows

.

3. Touch the Start/Pause button again

to start the programme immediately.

Changing the delay start after

the countdown has started

To change the delay start:

1. Touch the Start/Pause button to

pause the appliance. The related

indicator flashes.

2. Touch the Delay Start button

repeatedly until the display shows the

desired delay time.

3. Touch the Start/Pause button again

to start the new countdown.

10.8 The ProSense load

detection

The programme duration in

the display is referred to a

medium/high load.

After touching the Start/Pause button,

the maximum declared load indicator

goes off, the indicator flashes, the

ProSense starts the laundry load

detection:

1. The appliance detects the load in the

first 30 seconds: the indicator

and

the time dots

flash, the drum rotates

shortly.

2. At the end of the load detection, the

indicator goes off and the time

dots stop flashing. The programme

duration will be adjusted accordingly

and could increase or decrease. After

further 30 seconds, the water filling

starts.

At the end of the load detection, in case

of drum overload, the indicator is

flashing in the display:

In this case, for 30 seconds, it is possible

to pause the appliance and remove the

exceeding garments.

Once removed the exceeding garments,

touch the Start/Pause button to start the

programme again. The ProSense phase

can be repeated up to three times (see

point 1).

Important! If the laundry amount will not

be reduced, the washing programme

starts anyway, despite the overload. In

this case, it will be not possible to

guarantee the best washing results.

About 20 minutes after the

programme start, the

programme duration could

be adjusted depending on

the capacity of water

absorption of the fabrics.

www.electrolux.com24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Commentaires sur ces manuels

Pas de commentaire