Electrolux EWF12732 Manuel d'utilisateur télécharger pdf (Page 32)

32

www.electrolux.com

The inlet hose must not be

lengthened. If it is too short and

you do not wish to move the tap,

you will have to purchase a new,

longer hose specially designed for

this type of use.

This could be done by tying it to

the tap with a piece of string or

attaching it to the wall.

In a sink drain pipe branch. This

branch must be above the trap so

that the bend is at least 60 cm

above the ground.

Directly into a drain pipe at a

height of not less than 60 cm and

not more than 90 cm.

The end of the drain hose must

always be ventilated, i.e. the

inside diameter of the drain pipe

must be larger than the outside

diameter of the drain hose.

The drain hose must not be

kinked. Run it along the floor; only

the part near the drainage point

must be raised.

The end of the drain hose can be

positioned in three ways:

Hooked over the edge of a sink

using the plastic hose guide

supplied with the machine.

For the correct functioning of the

machine the drain hose must

remain hooked on the proper

support piece situated on the top

part of back side of the appliance.

In this case, make sure the end

cannot come unhooked when the

machine is emptying.

90 cm

60 cm

11.3 Water Drainage

“An incorrect power supply

may void your warranty.”

Check that your domestic electrical

installation can take the maximum

load required (2.2 kW or 2.0 kW for

PHILIPPINES), also taking into

account any other appliances in

use.

The manufacturer declines any

responsibility for damage or injury

through failure to comply with the

above safety precaution.

Should the appliance power

supply cable need to be replaced,

this shall be carried out by our

Service Centre.

When the appliance is installed

the power supply cable must be

easily accessible.

If this appliance is supplied from a

cord extension set or electrical

portable outlet device, the cord

extension set or electrical portable

device must be positioned so that

it is not subject to splashing or

ingress of moisture.

This machine is designed to operate

on a 220-240 V, single-phase, 50 Hz

(60 Hz for PHILIPPINES) supply.

11.4 Electrical Connection

Connect the machine to

an earthed socket outlet.

CAUTION!

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 103 104

Commentaires sur ces manuels

Pas de commentaire