Electrolux EHGL40XWE Manuel d'utilisateur télécharger pdf (Page 19)

commercially available. Make sure to avoid

any contact of the cleaning agent with the

catalytic coated walls and top.

Clean the oven door inner glass with warm

water and a soft cloth.

Remove all accessories and removable

shelf supports.

The walls and the top of the cavity are

catalytic-coated. They absorb fat and dirt

at a big heat without smell.

To support this self-cleaning process heat

the appliance without any food regularly.

Spots or discolouration of the

catalytic surface have no

effect on catalytic properties.

1. Touch again and again until the

display shows "Cata" and the duration

of the cleaning procedure (1 hour).

You cannot set the Duration, but you

can use the End function to delay the

start of the cleaning procedure.

An acoustic signal sounds after the time

ends. The appliance deactivates.

2. Touch any sensor field to stop the

signal.

3. Clean the bottom of the appliance

with a soft and moist sponge.

To protect the bottom from spoiling, insert

a cake tray while baking below the food.

Do not line the oven with aluminium foil

and do not place baking trays, pots, etc.

on the oven floor, as the heat that builds

up will damage the oven enamel.

11.4 Removing and installing the

door

You can remove the door to clean it.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3.

Close the door until it is at an angle of

approximately 45°.

45°

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

When the cleaning is completed, install the

door. Do the above steps in the opposite

sequence.

11.5 Replacing the lamp

Put a cloth on the bottom of the interior of

the appliance. It prevents damage to the

lamp glass cover and the cavity.

WARNING!

Danger of electrocution!

Disconnect the fuse before

you replace the lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box

or deactivate the circuit breaker.

The top lamp

1. Turn the lamp glass cover

counterclockwise to remove it.

ENGLISH

19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Commentaires sur ces manuels

Pas de commentaire