Electrolux EHI645BB Manuel d'utilisateur télécharger pdf (Page 7)

12 electrolux.com.au 13

Heat

setting

Use to: Time Hints Nominal

power

consumption

Keep cooked foods warm as required Cover 3%

1-3 Hollandaise sauce, melt: butter,

chocolate, gelatine

5 - 25 min Mix occasionally 3-8%

1-3 Solidify: ﬂuffy omelettes, baked

eggs

10 - 40 min Cook with a lid on 3-8%

3-5 Simmer rice and milk based

dishes, heating up ready-cooked

meals

25 - 50 min Add at least twice as much

liquid as rice, stir milk dishes

part way through

8-13%

5-7 Steam vegetables, ﬁsh, meat 20 - 45 min Add some tablespoons of

liquid

13-18%

7-9 Steam potatoes 20 - 60 min Use max. 1⁄4 L water for 750 g

of potatoes

18-25%

7-9 Cook larger quantities of food,

stews and soups

60 - 150 min Up to 3 L liquid plus

ingredients

18-25%

9-12 Gentle fry: escalope, veal cordon

bleu, cutlets, rissoles, sausages,

liver, roux, eggs, pancakes,

doughnuts

as necessary Turn halfway through 25-45%

12-13 Heavy fry, hash browns, loin

steaks, steaks

5 - 15 min Turn halfway through 45-64%

14 Boil large quantities of water, cook

pasta, sear meat (goulash, pot

roast), deep fry chips

100%

Boil large quantities of water.

Power management is activated.

Examples of cooking applications

The relation between the heat setting and the cooking

zone consumption of power is not linear. When you

increase the heat setting it is not proportional to the

increase of the cooking zone consumption of power.

It means that the cooking zone with the medium heat

setting uses less than a half of its power.

IMPORTANT

The data in the table is for guidance only.

Information on acrylamides

Important! According to the newest scientiﬁc knowledge,

if you brown food (especially food that contains starch),

acrylamides can pose a health risk. Thus, we recommend

that you cook at the lowest temperatures and do not brown

food too much.

The Power function is suitable for heating large quantities of water.

CARE AND CLEANING

Clean the appliance after each use.

Always use cookware with clean bottom.

IMPORTANT

Scratches or dark stains on the glass ceramic have no

effect on how the appliance operates.

To remove the dirt

1. Remove immediately: melted plastic, plastic foil, and

food with sugar. If not, the dirt can cause damage to

the appliance. Use a special scraper for the glass. Put

the scraper on the glass surface at an acute angle and

move the blade on the surface.

Remove after the appliance is sufﬁciently cool:

limescale rings, water rings, fat, stains, shiny metallic

discolourations. Use a special cleaning agent for glass

ceramic or stainless steel.

2. Clean the appliance with a moist cloth and some

detergent.

3. At the end rub the appliance dry with a clean cloth.

TROUBLESHOOTING

Problem Possible cause Remedy

Red rings, limescale or water

rings, shiny metallic or other

discolouration, scratches/

shadows, bubbles or other

miscellaneous marks or stains on

ceramic glass cooktop surface.

Cooktop surface has not been cleaned

correctly. Cleaning/ maintenance of the

cooktop surface is not covered under

warranty. If a service call is placed to

clean the cooktop you will be charged for

the visit.

Use a ceramic glass cleaner such

as Cerapol.

Pitting of ceramic glass surface. Spillovers of liquid with high sugar

content.

These types of spills must be removed

immediately with a special scraper for the

glass. If not permanent damage to the

cooktop glass can occur which is not

covered under warranty.

You cannot activate the

appliance or operate it.

• You touched 2 or more sensor ﬁelds at

the same time.

• The Stop+Go function operates.

• There is water or fat stains on the

control panel.

Activate the appliance again and set the

heat setting in less than 10 seconds.

Touch only one sensor ﬁeld.

Refer to the chapter “Operating instructions”

Clean the control panel.

An acoustic signal sounds and

the appliance deactivates. An

acoustic signal sounds when

the appliance is deactivated.

You put something on one or more

sensor ﬁelds.

Remove the object from the sensor ﬁelds.

The appliance deactivates. You put something on the sensor ﬁeld. Remove the object from the sensor ﬁeld.

The residual heat indicator does

not come on.

The cooking zone is not hot because it

operated only for a short time.

If the cooking zone operated sufﬁciently

long to be hot, speak to the service centre.

The Automatic Heat Up function

does not operate.

The cooking zone is hot.

The highest heat setting is set.

Let the cooking zone become sufﬁciently cool.

The highest heat setting has the same power

as the Automatic Heat Up function.

The heat setting changes

between two levels.

The Power management is activated. Refer to “Power management”.

Hob2Hood function does

not work

Object interrupting signal between hob

and the hood, or object covering the

control panel

Move items obstructing signal or covering

control panel

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire

Electrolux EHI645BB Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Electrolux EHI645BB