Electrolux ERHC938S Manuel d'utilisateur télécharger pdf (Page 10)

CHANGING THE HALOGEN LAMPS

WARNING!

Ensure lamp is cool before removing.

Usingasmallatbladescrewdriverremovetheinner

stainless steel ring to obtain access to the halogen globe.

When removing the inner ring, do so carefully, as the glass

lense could easily fall out of the inner ring. Remove the

halogen globe, whilst cool, and replace carefully with a

new globe.

TROUBLE SHOOTING

Troubleshooting guide

Problem Remedy

The cooker hood will not start •Checkthatcookerhoodisconnectedtoanelectricalsupply.

•Checkthatafanspeedhasbeenselected.

The cooker hood is not working •Checkthatfanspeedishighenoughforthetask.

•Thegreaseltersareclean.

•Thekitchenisadequatelyventedtoallowentryoffreshair.

•Checkductingandoutletsarenotblocked.

The cooker hood has switched off during

operation

•Thesafetydevicemayhavetripped–turnoffthecooking

appliance and wait for the device to reset. If the hood is

installed below the heights indicated in the installation

instructions the motor will cut out frequently which will damage

the cooker hood.

Ifyouhavecompletedalloftheabovechecksandarestillexperiencingdifculty,pleasecontactyourlocal

Electrolux Service Centre.

ERHC1238S cooker hood has 4 x 20W, 12 volt

halogen globes

ERHC938S cooker hood has 3 x 20W, 12 volt

halogen globes

IMPORTANT!

When handling globes hold with a cloth or gloves to

ensure perspiration does not come into contact with

a globe as this can reduce the life of the globe.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Electrolux ERHC938S Manuel d'utilisateur Page 10