Electrolux EGS6343NOX Manuel d'utilisateur

EGS6343NOX... ...EN HOB USER MANUAL

a solution to the problem yourself, speakyour dealer or the local Service ForceCentre.If you operated the appliance in-correctly, or the installation

8.1 Gas ConnectionChoose fixed connections or use a flexiblepipe in stainless steel in compliance withthe regulation in force. If you use flexiblemeta

WARNING!Make sure the flame does not goout when you quickly turn theknob from the maximum positionto the minimum position.8.4 Electrical connection• M

8.7 Possibilities for insertionKitchen unit with doorThe panel installed below the hob mustbe easy to remove and let an easy accessin case a technical

By-pass diametersBurner Ø By-pass in1/100 mmBurner Ø By-pass in1/100 mmAuxiliary 28 Triple Crown 56Semi-rapid 32 Gas burners for NATURAL GAS G20 20

ENGLISH 15

www.electrolux.com/shop892953047-B-362012

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY INSTRU

1. SAFETY INFORMATIONBefore the installation and use of the appliance, carefullyread the supplied instructions. The manufacturer is notresponsible if

• Never try to extinguish a fire with water, but switch offthe appliance and then cover flame e.g. with a lid or afire blanket.• Do not store items on

nect the appliance from the mains at allpoles. The isolation device must have acontact opening width of minimum 3mm.• Use only correct isolation devic

• Do not clean the burners in the dish-washer.• Clean the appliance with a moist softcloth. Only use neutral detergents. Donot use abrasive products,

thermocouple to warm up. If not, thegas supply will be interrupted.3.Adjust the flame after it is regular.If after some tries the burner doesnot light

5.1 Energy savings• If possible, always put the lids on thepans.• When the liquid starts to boil, turn downthe flame to barely simmer the liquid.Use c

• Make sure you position the pan sup-ports correctly after cleaning.• To make the burners work correctly,make sure that the arms of the pansupports ar