Electrolux EHG30800X Manuel d'utilisateur télécharger pdf (Page 7)

electrolux 7

Operation

Hob burner control knob

The symbols on the knob mean:

= no gas supply

= maximum gas supply

= minimum gas supply

For easier lighting, proceed before

putting a pan on the pan support.

Lighting the burner

To light the burner, turn the relevant

knob anticlockwise to maximum

position ( ) and push down the knob

to ignite.

After lighting the flame, keep the

knob pushed down for about 5

seconds. This will allow the

"thermocouple" to be heated and the

safety device to be switched off,

otherwise the gas supply would be

interrupted. Then, check the flame is

regular and adjust it as required.

If you cannot light the flame even

after several attempts, check the "cap"

and “crown” are in the correct position.

In the absence of electricity, ignition

can occur without the electrical device;

in this case approach the burner with a

flame, push the relevant knob down and

turn it anti-clockwise until it reaches the

"maximum" position.

To switch off burner

To put the flame out, turn the knob to

the symbol ( ).

)

Do not keep the control knob

pressed for more than 15 se-

conds.

If the burner does not light

even after 15 seconds, release

the control knob, turn it the

"off" position and wait for at

least one minute before trying

to light the burner again.

If the burner accidentally goes

out, turn the control knob to

the "off" position and wait for

at least 1 minute before trying

to light the burner again.

Take care when frying food in

hot oil or fat, as the overheated

splashes could easily ignite.

When switching on the mains, after

installation or a power cut, it is quite

normal for the spark generator to be

activated automatically.

)

A - Burner cap

B - Burner crown

C - Ignition candle

D - Thermocouple

A

B

C

D

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Commentaires sur ces manuels

Pas de commentaire