Electrolux EHG30830K Manuel d'utilisateur télécharger pdf (Page 10)

CARE AND CLEANING

Warning! Deactivate the appliance and

let it cool down before you clean it.

Disconnect the appliance from the

electrical supply before you do cleaning

or maintenance work.

Warning! For safety reasons, do not

clean the appliance with steam

cleaners or high-pressure cleaners.

Warning! Do not use abrasive

cleaners, steel wool pads or acids.

They can cause damage to the

appliance.

Scratches or dark stains on the surface

have no effect on how the appliance

operates.

• You can remove the pan supports to

easily clean the hob.

• To clean the enamelled parts, cap and

crown, wash them with warm soapy wa-

ter and dry them carefully before you put

them back.

• Wash stainless steel parts with water,

and then dry them with a soft cloth.

• The pan supports are not dishwasher

proof. They must be washed by hand.

• When you wash the pan supports by

hand, take care when you dry them as

the enamelling process occasionally

leaves rough edges. If necessary, remove

stubborn stains using a paste cleaner.

• Make sure you position the pan supports

correctly after cleaning.

• To make the burners work correctly,

make sure that the arms of the pan sup-

ports are in the centre of the burner.

•

Be very careful when you replace the

pan supports to prevent the hob top

from damage.

After cleaning, dry the appliance with a soft

cloth.

Removing the dirt:

1. – Remove immediately: melting plas-

tic, plastic foil, and food containing

sugar.

– Stop the appliance and let it cool

down before you clean: limescale

rings, water rings, fat stains, shiny

metallic discolorations. Use a special

cleaner applicable for surface of hob.

2. Clean the appliance with a damp cloth

and some detergent.

3. At the end rub the appliance dry

with a clean cloth.

Cleaning of the spark plug

This feature is obtained through a ceramic

ignition candle with a metal electrode. Keep

these components well clean to prevent dif-

ficult lighting and check that the burner

crown holes are not obstructed.

Periodic maintenance

Periodically speak your local Service Force

Centre to check the conditions of the gas

supply pipe and the pressure adjuster, if fit-

ted.

WHAT TO DO IF…

Problem Possible cause Remedy

There is no spark when lighting

the gas

• There is no electrical supply • Make sure that the unit is

connected and the electrical

supply is switched on.

• Control the fuse. If the fuse is

released more than one time,

refer to a qualified electrician.

• Burner cap and crown are

placed uneven

• Make sure that the burner

cap and crown are in correct

positions.

The flame is blow out immedi-

ately after ignition

• Thermocouple is not heated

sufficient

• After lightning the flame,

keep the knob pushed for

approximately 5 seconds.

10 electrolux

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire