Electrolux EHL2S7000W Manuel d'utilisateur télécharger pdf (Page 24)

3. Close the door until it is at an angle of

approximately 45°.

45°

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

6. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, install

the door. Do the above steps in the

opposite sequence.

Replacing the lamp

Put a cloth on the bottom of the interior of

the appliance. It prevents damage to the

lamp glass cover and the cavity.

WARNING! Danger of

electrocution! Disconnect the

fuse before you replace the

lamp.

The lamp and the lamp glass

cover can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box or

deactivate the circuit breaker.

The top lamp

1. Turn the lamp glass cover

counterclockwise to remove it.

2. Clean the glass cover.

3. Replace the lamp with a halogen, 230

V, 40 W, 300 °C heat resistant lamp.

4. Install the glass cover.

TROUBLESHOOTING

WARNING! Refer to Safety

chapters.

What to do if...

Problem Possible cause Remedy

The cooking zones do not

operate.

Refer to the operating instructions for the built-in cooking sur‐

face.

The oven does not heat up. The oven is deactivated. Activate the oven.

The oven does not heat up. The fuse is blown. Make sure that the fuse is

the cause of the malfunc‐

tion. If the fuse is blown

again and again, contact a

qualified electrician.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Electrolux EHL2S7000W Manuel d'utilisateur Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Electrolux EHL2S7000W