Electrolux EKE5001 Manuel d'utilisateur télécharger pdf (Page 6)

6

ELECTRICAL CONNECTIONS

Any electrical work required to install

this hob and the supply cable should be

carried out by a qualified electrician or

competent person, in accordance with the

current regulations.

THIS COOKER MUST BE EARTHED.

The manufacturer declines any liability

should these safety measures not be

observed.

Before any maintenance or cleaning can

be carried out, you must DISCONNECT the

cooker from the electricity supply.

This cooker is designed to be connected to a

230/400V, 50Hz electrical supply.

To connect to the electricity supply, use cable type

H05 RR-F.

Before switching on, make sure the electricity

supply voltage is the same as that indicated on

the rating plate.

The cooker is supplied without supply cord. A

flexible supply cord must be fitted, in

accordance with the specification gived in the

relevant table no. 1.

In case of a direct connection to the mains you

have to interpose an omnipolar switch a

minimum opening between contacts of 3 mm.

The switch should be sited within 2m of the hob

and be easily accessible upon completion of the

installation.

The yellow-green grounding cable has not to be

interrupted by the switch.

NOTE: The earth wire should be about 2 cm

longer than the live and neutral wires.

Ensure that the cooker supply cable does

not come into contact with any part of the

hatched area shown in the diagram.

supply

cable

If the supply cord is damaged, the

manufacturer or its service agent or a

similarly qualified person must replace it in

order to avoid a hazard.

Before connecting check that:

• fuse and household electric installation can

bear the charge of the appliance (see rating

plate);

• The socket or the omnipolar switch used for

connection is easily reachable when the

appliance is installed.

How to proceed?

• Unscrew and remove the protective cover at

the back of the appliance;

• Connect the power cord to the terminal of the

cooker according to the table no.1;

• Fix by means of cable clamp;

• Make sure that the connection to the terminal

is matching the network power;

• Remount and screw the protective cover at the

back of the appliance

Table no. 1

Rated voltage 230V 1N, 230/400V 3N, 230V 3~, 230/400V 2N

Connection type Single phase

Tri-phase Y 3 ph.

+ neutral

Tri-phase

Bi-phase Y 2 ph. +

neutral

Cable connection to the

terminal plate

1 2 3

4 5

L1

N

PE

3

L3L1

PE

4 5

N

L2

1 2

L3

5

1 2

3 4

L1 L2

PE

4 5

N

PE

2 3

L2L1

1

Network voltage

1N/ 230 V 3N/400 V 3/230 V 2N/400 V

Voltage of heating

elements

230 V 230 V 230 V 230 V

Fusible capacity

35 A 3 x 16 A 3 x 20 A 2 x 25 A

Cable section

3 x 6 mm

2

5 x 2,5 mm

2

4 x 4 mm

2

4 x 4 mm

2

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Commentaires sur ces manuels

Pas de commentaire