Electrolux EKI6751AOX Manuel d'utilisateur télécharger pdf (Page 41)

3.

You can find the hole on the left side

at the back of the appliance (see fig.).

Lift the front of the appliance (1) and

put it in the middle of the space be-

tween the cupboards (2). If the space

between the bench cupboards is

larger than the width of the appliance,

you must adjust the side measure-

ment to centre the appliance.

Make sure that the surface behind the

appliance is smooth.

1

2

49 mm

77 mm

13.4 Electrical installation

WARNING!

Only a qualified and competent

person must do the electrical in-

stallation.

The manufacturer is not responsi-

ble if you do not follow safety pre-

cautions from the chapter "Safety

information".

This appliance is supplied without a main

plug or a main cable.

13.5 Covering terminal board

The recommended cross-section area is

six square millimetres (6 mm²).

When you refit the mains terminal cover,

make sure that the lower tabs are located

inside the bottom edge of the aperture,

before you fix the two screws into the top

edge of the mains terminal cover.

Make sure that the cover is securely fas-

tened.

To open the cover of terminal

board obey the procedure in op-

posite sequence.

13.6 Terminal board

Make sure that the links are fitted as

shown.

NNN

LL

Do not remove blanking plates.

14. ENVIRONMENT CONCERNS

Recycle the materials with the symbol

. Put the packaging in applicable

containers to recycle it.

Help protect the environment and human

health and to recycle waste of electrical

and electronic appliances. Do not dispose

appliances marked with the symbol

ENGLISH 41

1 2 ... 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire