Electrolux GME263XW Manuel d'utilisateur

GME263EN Hob User Manual

6.3 Cleaning the hob• Remove immediately: melted plastic,plastic foil, and food with sugar. If not,the dirt can cause damage to the hob.• Remove when

7.2 If you cannot find asolution...If you cannot find a solution to theproblem yourself, contact your dealer oran Authorised Service Centre. Give thed

they do not come in touch with mobileparts or they are not squeezed. Also becareful when the hob is put together withan oven.Make sure that the gassup

• from natural gas G20 13 mbar ornatural gas G20 20 mbar to liquidgas, fully tighten the bypassscrew in.• from liquid gas to natural gas G2013 mbar, u

ABA) supplied sealB) supplied bracketsCAUTION!Install the appliance only ona worktop with flat surface.8.8 Possibilities for insertionThe panel instal

Gas connection: G 1/2" Appliance class: 3 9.4 Gas burners for NATURAL GAS G20 13 mbarBURNER NORMAL POWERkWMINIMUM POWERkWINJECTOR MARK1/100 mmR

www.electrolux.com/shop867321591-B-182015

CONTENTS1. SAFETY INFORMATION...22. SAFETY INSTRUCTIONS...

injuries and damages. Always keep the instructions withthe appliance for future reference.1.1 Children and vulnerable people safety• This appliance ca

• If the supply cord is damaged, it must be replaced bythe manufacturer, an authorized Service or similarlyqualified persons in order to avoid a hazar

• Use the strain relief clamp on thecable.• Make sure the mains cable or plug (ifapplicable) does not touch the hotappliance or hot cookware, when you

• Do not let cookware to boil dry.• Be careful not to let objects orcookware fall on the appliance. Thesurface can be damaged.• Do not activate the co

3. PRODUCT DESCRIPTION3.1 Cooking surface layout1 2341Semi-rapid burner2Rapid burner3Auxiliary burner4Control knobs3.2 Control knobSymbol Descriptionn

lets the thermocouple warm up. Ifnot, the gas supply is interrupted.3. Adjust the flame after it is regular.If after some tries the burnerdoes not lig

CAUTION!Make sure that the pots areplaced centrally on theburner in order to getmaximum stability and to getlower gas consumption.5.2 Energy saving• I