Electrolux FAC124P1A Instructions d'exploitation télécharger pdf (Page 68)

Section 4 Component Teardown

4-8

Heater Removal

To remove the heater:

1. Disconnect power supply from unit.

2. Remove the front panel assembly. Pull the unit from

the cabinet wrapper/sleeve. Remove the blower

scroll front cover.

3. Disconnect the heater electrical leads, the red wire

from the control board and the white wire from the

terminal block.

4. Remove the left bulkhead partition with the

electronic components.

5. Extract the two screws from each side of the

evaporator securing heater housing to back of the

evaporator. (See Figure 4-15)

6. Carefully pull the heater housing out from behind

evaporator.

7. Lay the heater and front scroll cover on a flat

surface and extract the two screws securing the

heater assembly to the front scroll cover. (See

Figure 4-12)

8. Slide heater assembly to the left until the metal

legs are free of the retaining slots then pull heater

assembly off of front scroll cover.

Figure 4-15. FAM Series With Heat

Screws

Figure 4-16.

Screws

If the thermal limiter and/or the thermostat are

defective, the entire heater assembly must be replaced.

NOTE

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 139 140

Pas de commentaire

Electrolux FAC124P1A Instructions d'exploitation Page 68