Electrolux FAC124P1A Instructions d'exploitation télécharger pdf (Page 73)

Section 4 Component Teardown

4-13

Condenser Removal

To remove the condenser:

1. Disconnect power supply from unit.

2. Remove the front panel and cabinet wrapper/sleeve.

3. Remove the condenser fan cover.

4. Attach an approved self tapping line tap valve to the

process tube. Connect refrigerant recovery system

to tap valve. Turn on recovery system, open the

line tap valve, and allow refrigerant to flow into an

approved tank.

5. Disconnect inlet and outlet lines from condenser.

6. Extract the two screws securing the bottom of the

condenser to the unit base. (See Figure 4-29)

7. Carefully lift the condenser out from the unit base.

Evaporator Removal

To remove the evaporator:

1. Disconnect power supply from unit.

2. Remove the front panel and cabinet wrapper/sleeve.

3. Remove the fan and blower assembly.

4. Attach an approved self tapping line tap valve to the

process tube. Connect refrigerant recovery system

to tap valve. Turn on recovery system, open the

line tap valve, and allow refrigerant to flow into an

approved tank.

5. Disconnect inlet and outlet lines from evaporator.

6. Extract the two screws securing the bottom front of

the evaporator to the unit base. (See Figure 4-30)

7. Carefully lift the evaporator out from the unit base.

Screws

Figure 4-29.

Figure 4-30.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 139 140

Pas de commentaire

Electrolux FAC124P1A Instructions d'exploitation Page 73