Electrolux EHT7780K Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
4
Before carrying out any operation, disconnect
the appliance from the power supply and
allow it to cool.
General cleaning
Clean the enamelled parts with lukewarm water and
detergent; do not use abrasive products which could
damage them. Clean the flame spreader and caps
frequently with boiling water and detergent, making sure
to remove all deposits.
The worktop grates can be placed in a dishwasher.
For stubborn stains, use normal non-abrasive
detergents or specific products, readily available on the
market.
DO NOT use scouring pads, steel wool or acids.
Automatic ring lighting is ensured by the
presence of a ceramic igniter plug and a
metal electrode (Fig. 1, B). Carefully clean
these parts of the top periodically. Also, to
prevent difficulty in lighting, make sure the
burner cap holes are not clogged.
To remove deposits from the burner cap holes
(auxiliary and semirapid), remove the two fix-
ing screws at the bottom of the cap and sepa-
rate the two parts (Fig. 3). After cleaning, reas-
semble the two parts and refit them correctly
on the burner.
After washing, refit the top grates, making sure they
are correctly positioned.
Worktop
Clean the glass top regularly with a soft cloth soaked in
lukewarm water and a little liquid detergent. Do not use
the following products:
- household detergents or bleaches;
- soapy scouring pads not suitable for non-stick
recipients;
- steel wool;
- bath or sink stain removers.
If the glass top is very dirty, use specific products
available on the market.
If you note breakage or cracks on the glass
top, immediately disconnect the appliance,
contact a Technical Assistance Centre and do
not use the appliance until it is repaired.
A
C
I
D
O
FO 2094
Fig. 2
FO 2265
Fig. 3
Cleaning and maintenance
For correct use of the rings
To ensure lower gas consumption and better efficiency,
only use flat bottom recipients of suitable size for the
rings, as given in the table at the foot of the page.
Also, as soon as a liquid starts to boil, lower the flame
enough to keep it on the boil.
Burner min max
diameter diameter
Triple crown 160 mm. 260 mm.
Medium (semirapid) 120 mm. 220 mm.
Small (auxiliary) 80 mm. 160 mm.
Vue de la page 3
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire