Electrolux EHT9780K Manuel d'utilisateur télécharger pdf (Page 7)

A) Gas train end with nut

B) Seal

C) Adjustable union

Fig. 7

Gas supply connection

The gas connection must be carried out in compliance

with standards. The appliances leave the factory tested

and adjusted for the type of gas specified on the plate

located in the bottom protection, near the gas connection

pipe. Make sure the type of gas used is the same as

that specified on the plate.

Otherwise, proceed according to the instructions given

in the section “Converting to different types of gas”.

To ensure maximum efficiency and lower consumption,

make sure the gas supply pressure respects the values

given in the “Burner specifications” table.

If the pressure of the gas used is different (or variable)

from that provided for, a suitable pressure regulator for

the piped gas (NOT LPG), complying with Standard UNI-

CIG 7430, must be installed on the

inlet piping.

The use of pressure regulators for liquified gases (LPG)

is allowed provided they comply with Standard.

The union is fitted on the end part of the gas train, with a

G 1/2" threaded nut, interposing the seal between the

components as shown in Fig.7. Screw the parts without

forcing, turn the union in the required direction, then

tighten everything.

FO 0264

Fume exhaust

Gas cooking appliances must exhaust the fumes

through hoods directly connected to flues or directly to

the outside (Fig. 5).

If a hood cannot be installed, it is necessary to use

electric exhaust fans applied to the external wall or the

window of the room, provided conditions exist so that the

opening for ventilation can be increased (see fig.6) in

proportion to the performance of the electric fan.

The electric exhaust fan performance must be able to

guarantee an hourly air exchange, for a kitchen, equal

to 3 - 5 times its volume.

Connection

Make the connection to the gas system using a rigid

metal pipe and fittings complying with Standard, or with

a s/steel flexible tube complying with Standard UNI-CIG

9891, limited to those not longer than 2 m. When using

flexible metal tubes make sure they are not in contact

with movable parts or squashed. Pay the same attention

also when an oven and top combination is provided for.

The gas inlet union for the appliances is 1/2" cylindrical

male thread.

Make the connection, avoiding any kind of stress on the

appliance.

IMPORTANT

· After installation, always check the perfect seal of

all unions using a soapy solution. Never carry out

this check with a flame.

If the opening cannot be made in the room where the

appliance is installed, the necessary air can come from

an adjacent room, provided:

• it is not a bedroom or a dangerous environment;

• it is not in depression;

• the ventilation between the room where the appliance

is installed and the adjacent room is ensured by

means of permanent openings (UNI-CIG 7129).

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Electrolux EHT9780K Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Non Electrolux EHT9780K