Electrolux RC3000EGP Manuel d'utilisateur télécharger pdf (Page 5)

5

3. Cleaning

Clean both the inside and outside of the

appliance before putting it into use.

To do so, use a soft towel, lukewarm water and a

non-abrasive detergent. Ensure water does not

enter the rear cover grille or the control elements.

Afterwards, wipe the appliance with a clean towel

and cleanwater, and then wipe it dry.

To avoid damage, do not use soap, soda or

abrasive cleaners.

4. Positioning the appliance

During the refrigeration process, the appliance

gives off heat from the condenser (under the

upper part of the rear cover) into the surrounding air.

The more ventilated the condenser is, the more

effective the refrigeration will be.

The other condition for satisfactory operation is that

the appliance stands on a flat surface. This is best

seen by placing a glass of water on top of the

appliance.

It is important that the appliance is not directly

exposed to radiated heat (sunlight, radiator, near an

oven, etc.).

In gas operation from the back side of the

appliance minimum 10cms, from both sidewalls

4cms each, from the top of the appliance minimum

30 cms, from the bottom minimum 5cms

clearances should be kept.

In the immediate vicinity of the appliance within the

specified distances no inflammable matters (paper,

wood, grass, textile etc.) should be met with.

5. Using the appliance

The cable for mains connection, the 12V connecting

cable and the connector for the gas hook-up are

located on the right-hand side of the rear cover of the

cooling box, behind the door (Figure 2).

5.1. Operating from electrical mains

Make sure the voltage shown on the data plate of the

appliance matches that of the mains voltage to which

you wish to connect the appliance. After opening the

door, pull out the mains connecting cable and

connect it to a receptacle earthed socket for

connection.

When connecting the appliance for the first time, set

the thermostat to maximum; then, after about five

hours, set it back to a medium position. This is

suitable for general refrigeration requirements.

NB: Plug is provided according to specific

regulations in each country and may be different to

that shown.

Figure 2.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire