Electrolux WASL1E101 Manuel d'utilisateur

user manualWashing MachineWA SL1 E 101WA SL2 E 101

and then by 1 hour up to a maximum of 20hours by means of this button.The selected delay time value will appear onthe display for about 3 seconds, the

If you do not intend to carry out anotherwash, close the water tap. Leave the dooropen to prevent the formation of mildew andunpleasant smells.Stand b

The detergent and any additives must beplaced in the appropriate compartments ofthe dispenser drawer before starting thewash programme.If using liquid

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergent Com-partment40- 60 MIXMIXED FABRICS40°Mai

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergent Com-partmentVISKOSE - VISCOSEVISCOSE40° -

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergent Com-partmentDESSOUS - LINGERIE (Handwash)

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Fabrics LoadType of LaundryOptionsDetergent Com-partmentSUPER ECOColdMain wash - Rins

External cleaningClean the exterior cabinet of the appliancewith soap and water only, and then dry thor-oughly.Important! Do not use methylated spirit

6. When no more water comes out, un-screw the pump and remove it. Alwayskeep a rag nearby to dry up spillage ofwater when removing the pump.7. Remove

6. Clean the filter in the valve with a stiffbrush or with the piece of cloth.7. Screw the hose back to the machine andmake sure the connection is tig

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comContentsSafety information 2Product description 4Control panel 4P

Problem Possible cause/SolutionThe washing machine does not start:The door has not been closed. • Close the door firmly.The plug is not properly inser

Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent (cre-ates too much foam) has been used.• Reduce

Problem Possible cause/SolutionSpinning starts late or the machine does notspin:The electronic unbalance detection device hascut in because the laundr

Spin Speed Maximum 1600 rpmConsumption valuesProgramme Energy consumption(KWh)Water consumption(litres)Programme duration(Minutes)White Cottons 95° 2.

4. Slide out the relevant plastic spacers.5. Open the porthole, take out the inlet hosefrom the drum and remove the polystyr-ene block fitted on the d

Water inletAn inlet hose is supplied and can be foundinside the machine drum.Caution! This appliance must beconnected to a cold water supply.Do not us

Water drainageThe end of the drain hose can be positionedin three ways:1. Hooked over the edge of a sink usingthe plastic hose guide supplied withthe

The power supply cable must beeasily accessible after installing themachine.Should the appliance power supplycable need to be replaced, this mustbe ca

132948860- 00 -062010www.electrolux.comelectrolux.ch

Installation• This appliance is heavy. Care should betaken when moving it.• When unpacking the appliance, check thatit is not damaged. If in doubt, do

Product descriptionYour new appliance meets all modern re-quirements for effective treatment of laundrywith low water, energy and detergent con-sumpti

1234567 891 Programme selector dial2 TEMPERATURE button ( TEMP. )3SPIN reduction button ( U/MIN. - ES-SORAGE )4 OPTION button ( OPTION - OPTIONS )5OK

• During a washing cycle, a black line blinksunder the washing phase symbol of therunning programme. At the end of eachwashing phase, the line under t

First use• Ensure that the electrical and waterconnections comply with the installa-tion instructions.• Remove the polystyrene block andany material f

Select the required programme bymeans of programme selector dial (1)You can choose the right programme for anytype of laundry following the descriptio

has been set. Press the same button to de-activate the option.After selecting the options, wait about fewseconds until the display gets back to thedef