Electrolux WASL5M101 Manuel d'utilisateur télécharger pdf (Page 48)

X In future, please reduce the detergent quantity (if

re quired use washing powder instead of liquid deter-

gent).

«WATER LEVEL TOO HIGH»

 Too much foam in the washing machine, spinning has

not been effected. There are two possibilities to solve

the problem:

a) Press the Start button and then interrupt the pro-

gramme by pressing the Quick Wash button several times

until the display «OPEN DOOR» appears.

Mix approx. 30 ml conditioner and approx. 1 litre water.

Start the previously selected wash programme (it may

take several minutes until the machine is released for

the

selection of a new programme). After the water

s upply has been com pleted, switch forward immediately

to «Conditio ning» by pressing the Quick Wash button

and add the conditioner- water mixture into section I of

the detergent drawer. The programme should now end

usually and the spinning process should take place.

After

wards repeat the desired programme, however

without any detergent.

Press the Start button and then interrupt the pro-

gram me by pressing the «Quick wash» button several

times

until the display «OPEN DOOR» appears. Wait for

approx.

1 hour and start the previously selected wash

programme,

move forward immediately to «spinning»

using the Quick

Wash button. Usually the laundry will

be spun. If not, repeat the procedure including waiting

for 1

hour. After wards repeat the desired programme,

however

without any detergent.

X The maximum admissible water level is reached. Wait

until the water has been pumped out completely and

press the Start button. The programme will continue.

«WATER IS BEING PUMPED OUT»

 Too much water is in the washing machine. Water is

pumped off to the set level.

 If you see a lot of foam in the door glass, this means

that too much foam is in the washing machine.

To eliminate this problem proceed as for the error mes-

sage «Water level too high».

 In future, please reduce the detergent quantity.

If the appliance shows a function fault F – –:

X Stop the programme with the Quick Wash button

and select a new programme.

In the event of repeated error messages:

X Disconnect the electricity for approx. 1 minute and

then switch on again. (Withdraw the mains plug or

switch off the main building switch.)

X The machine is ready to operate once again when the

programme pilot lamps ash.

X Select a new programme.

If the error message still appears:

X Make a note of the error message

X Switch off the water tap and withdraw the mains

plug or switch off the main building switch.

X Inform Customer Service.

Error messages / Cash-Card

The following fault displays are connected with the

Cash-Card.

«CARD UPSIDE DOWN»

X Insert the Cash- or Wash-Card with the

symbol

facing upwards.

«CARD EMPTY OR BALANCE TOO SMALL»

X Use a charged Cash-Card.

«CASH-CARD INVALID»

X The Cash-Card being used is not permitted. Notify the

person responsible for the facility.

«REINSERT CASH-CARD»

X Wait 5 seconds until the amount on account has been

deducted and the new Cash-Card balance appears.

Troubleshooting

Other minor faults, which you can rectify yourself.

Machine operation

Display is dark:

X The machine is in standby mode. No error. To operate

the machine press any key.

The machine cannot be switched on, display

remains dark even after pressing a key:

X Check whether the mains power is switched on at the

wall and the plug is in.

X Check whether all the fuses are intact or the safety

switch has tripped.

X Mains blockage, generally at noon. Operate the

machine after the mains blockage has ended. .

The machine does not start:

X The Start button has not been pressed.

X Start time preselect has been set. Only starts at the

preselected start time.

Loading door cannot be opened:

X Programme not yet nished.

X «Rinsing stop» selected. No error; see chapter

«Washing/Ending the programme with rinsing stop».

X Mains blockage or appliance defect: see below.

Open the door in the event of a power failure

or machine defect as follows:

X Check that the drum is standing still.

X Turn off the water tap!

X Switch off the mains power supply.

X Carry out emergency emptying (see chapter «Clean-

ing and Maintenance»).

X Pull on the door opener (Emergency opener).

Machine with drain pump:

1 2 ... 43 44 45 46 47 48 49 50 51 52

Commentaires sur ces manuels

Pas de commentaire

Electrolux WASL5M101 Manuel d'utilisateur Page 48

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Electrolux WASL5M101