
61
USING THE EXTRACTOR FAN
Power-on
Press (touch)
ON/OFF hob/ extractor
The indicator light will turn on to indicate that the hob/extractor is
ready for use
Press again to turn off
Note: This function has priority over the others.
Switching on the extractor fan:
Touch (press) the selector
to activate the extractor fan
Extraction speed (power):
touch (press) the selector
, to increase the extraction
speed (power) (0-10);
touch (press) the selector
, to decrease the extraction
speed (power) (10-0);
12. Timer
Activation/Regulation of Timer function for the extractor
fan
• Select the extractor fan
• Press
(5) to access the Timer function (from any
speed)
• Regulate the duration of the Timer:
press the selector
, to increase the automatic shut-
down time
press the selector
, to decrease the automatic shut-
down time
the display (10) will show the countdown,
Note: on the side of the display of the extractor fan, with the Timer
in use, the following symbol will appear
(9)
When the timer has finished the countdown, there is an acoustic
signal (for 2 minutes, or it will stop when one of the buttons on the
hob is pressed) , while the display (10) will flash, with the symbol
“
".
To switch off the Timer:
• select the cooking zone
• set the value of the timer to "
" , by means of
Note: the function remains active if no other key is pressed in
the meantime.
Filter saturation indicator
The hood indicates when filter maintenance is needed:
Grease filter
the
“ ”(11) LED lights up
Activated carbon odour filter
the
“ ”(11) LED flashes
Reset filter saturation
After carrying out maintenance on the filters (grease and/or
activated carbon) hold down the
key;
the
“ ” LED turns off and the count restarts.
Activation of activated carbon odour filter saturation
indicator
This indicator is normally deactivated
.
To activate it, proceed as follows:
- turn on the aspiration hob by pressing
;
- with the aspiration motor and cooking zones off, press and hold
;
-
“ ” turns on, then off to indicate successful activation.
Deactivation of activated carbon odour filter saturation
indicator
repeat the activation steps described above
“ ” flashes, then turns off to indicate successful deactivation.
Automatic mode (Hob2Hood)
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the cooking level used in the cooking zone.
Once the hob is turned off, the hood adapts its aspiration speed,
gradually decreasing it, so as to eliminate residual vapours and
odours
To activate this function:
Briefly press
, LED (11) will light up to indicate that
the hood is working in this mode.
Commentaires sur ces manuels