Electrolux EBKSL6CN Manuel d'utilisateur télécharger pdf (Page 20)

2. Pull the rear end of the shelf support

away from the side wall and remove

it.

2

1

Install the shelf supports in the opposite

sequence.

11.3 Catalysis

Remove all accessories and removable

shelf supports.

The walls with a catalytic coating are

self-cleaning. They absorb fat which

collects on the walls while the appliance

operates.

The catalytic cleaning

procedure cannot start:

• If you do not remove the

shelf support or

telescopic shelf runners

(if present).

• if you did not fully close

the oven door.

Spots or discolouration of

the catalytic surface have no

effect on catalytic properties.

During the catalytic cleaning the oven

lamp is on.

1. In the main menu select the

function:Catalysis

2. Press to confirm.

The display shows the time of day and

the duration of the cleaning procedure (1

hour). You cannot change the duration,

but you can delay the start of the

cleaning procedure with the function:

End Time.

When the oven is at the set

temperature, the door locks.

An acoustic signal sounds after the time

ends. The appliance deactivates.

3. Touch a sensor field or open the

oven door to stop the signal.

4. Wipe the bottom of the appliance

with a soft and moist sponge.

11.4 Removing and installing

the door

You can remove the door to clean it.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A)

on the two door hinges.

A

A

3. Close the door until it is at an angle

of approximately 45°.

45°

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

www.electrolux.com20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Commentaires sur ces manuels

Pas de commentaire