Electrolux EBSL7EEV Manuel d'utilisateur télécharger pdf (Page 24)

AB

min. 20

10

20

A

1.

Pull the appliance drawer out as far

as it goes and remove it.

2.

Use the side handles to hold the oven

and slide it flush into the recess.

CAUTION!

Make sure the cable is free when

you move the appliance.

3.

Use a minimum of 2 screws to attach

the oven on the 2 sides (Detail A).

13.3 Electrical connection

Use a power cable of H05VV-F or higher.

Connect the appliance to a socket supply

line. If there is no socket supply line, the

electrical installation must have an isola-

tion device which lets you disconnect the

appliance from the power supply. The iso-

lation device must have a contact opening

width of minimum 3 mm (in reference to

NIN SEV 1000). The customer must have

a socket for the electrical connection that

is accessible and outside the coordination

room. The length of the connection cable

must be approximately 120 cm with lines

connected directly to the power supply.

D

E

F

Only a qualified person can con-

nect the appliance to the electrici-

ty supply.

1.

Open the mains terminal cover (D).

2.

Put the connection cable into the

supplied rings (E). This is to prevent

the cable from rubbing against the

drawer. The connection cable is on

the housing side.

3.

Install the cable grip (F).

4.

Connect the terminal as in the illustra-

tion.

5.

Put the cable into the strain relief

clamp.

6.

Close the mains terminal cover.

13.4 Connection diagram 400 V

400V3N

400V2N

Phase definitions: L1, L2, L3 (or R, S,T)

WARNING!

If service is required always dis-

connect the appliance from the

power supply.

24

www.electrolux.com

1 2 ... 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire