
4
Electric Hotplates
To switch on a hotplate, turn the relevant control knob
anticlockwise to the required heat setting.
The control knob is numbered 1 - 6
0 - OFF
1 - Minimum
2 - Maximum.
The hob has two types of hotplates:
Normal Hotplates
We recommend the plates are switched to maximum
(6) for a short while to boost the plate, and then
adjusted to the required setting.
Rapid Hotplates
The rapid hotplates are indicated by a red dot, and will
heat up more quickly than a normal plate. As the red
dots are painted on the plate, they may deteriorate
during use and even disappear completely after a
period of time. This will not affect the performance
of the hob.
Operation
OFF 0
Very Gentle 1 To keep food warm
To melt butter and chocolate
Gentle 2 To prepare cream-sauces,
stews and milk puddings
or to fry eggs
Slow 3 Dried vegetables, frozen
food, fruit, boiling water
or milk
Medium 4 Boiled potatoes, fresh
vegetables, pâtés, soups,
broths, pancakes or fish
High 5 Larger stews, meat roll, fish,
omelettes, steaks
Fast 6 Steaks, escalopes and frying.
i
1. Hob Top
2. Rapid Hotplate - 2090 W/180 mm dia.
3. Normal Hotplate - 1570 W/180 mm dia.
4. Rapid Hotplate - 1570 W/145 mm dia.
5. Normal Hotplate - 1040 W/145 mm dia.
6. Control knob for back left hotplate
7. Control knob for front left hotplate
8. Control knob for front right hotplate
9. Control knob for back right hotplate
10.Electric Hotplates Control Light
Description of the Hob
Installation
The hob must be installed according to the
instructions supplied.
The hob must be installed by qualified
personnel to the relevant British Standards.
Please, ensure that, once the hob is installed, it
is easily accessible for the engineer in the event
of a breakdown.
When the hob is first installed
Once the hob has been installed, it is important
to remove any protective materials, which were
put on in the factory.
1
3
2
5
4
6
7
8
9
10
It is important to note that the plate may smoke
a little and produce a slightly unpleasant odour
when used for the first time. This is quite normal
and will disappear after a few minutes.
Suggestions for the correct setting of the plates are
given in the following table.
Commentaires sur ces manuels