Electrolux EQG4120BOG Manuel d'utilisateur télécharger pdf (Page 10)

Make sure that there is a stop tap assem-

bled between the gas supply of house

and the appliance.

The settings for this appliance are located

on the rating plate. The present settings

for the type of gas and gas pressure are

on a sticker

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

This appliance is not connected to an ex-

haust gas outlet. It must be connected in

accordance with the installation condi-

tions that apply. Pay special attention to

correct airflow.

Make sure that the gas supply pressure of

the appliance obeys the recommended

values. The adjustable connection is fixed

to the comprehensive ramp by means of

a threaded nut G 1/2". Screw the parts

without force, adjust the connection in the

necessary direction and tighten every-

thing.

ABC

A)

End of shaft with nut

B)

Gasket

C)

Elbow

WARNING!

After installation always check the

tightness of the connections using

a soap solution. Never use a

flame to check the tightness.

Flexible nonmetal pipes

connection:

If it is possible to easily control the con-

nection in its full area, you can use a flexi-

ble pipe. Tightly attach the flexible pipe by

clamps.

Liquid gas: use the rubber pipe holder.

Always engage the gasket. Then continue

with the gas connection. The flexible pipe

is prepared for apply when:

– it is no longer than 1500 mm;

– it shows no throttles;

– it is not subject to traction or torsion;

– it does not get in touch with cutting

edges or corners;

– it can be easily examined in order to

check its condition.

The control of preservation of the flexible

pipe consists in checking that:

– it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

– the material is not hardened, but shows

its correct elasticity;

– the fastening clamps are not rusted;

–expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

When installation is complete,

make sure that the seal of each

pipe fitting is correct. Use a soapy

solution, not a flame!

8.2 Injectors replacement

1.

Remove the pan supports.

2.

Remove the caps and crowns of the

burner.

3.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use.

4.

Assemble the parts, follow the same

procedure backwards.

10

www.electrolux.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire