Electrolux EQH4512BOG Manuel d'utilisateur télécharger pdf (Page 13)

7. TROUBLESHOOTING

Problem Possible cause Remedy

You cannot activate the

appliance or operate it.

Activate the appliance

again and set the heat

setting in less than 10

seconds.

You touched 2 or more

sensor fields at the same

time.

Touch only one sensor

field.

The STOP+GO function

operates.

Refer to the chapter “Daily

Use”.

There is water or fat

stains on the control

panel.

Clean the control panel.

An acoustic signal

sounds and the appliance

deactivates.

An acoustic signal

sounds when the appli-

ance is deactivated.

You put something on

one or more sensor

fields.

Remove the object from

the sensor fields.

The appliance deacti-

vates.

You put something on

the sensor field

.

Remove the object from

the sensor field.

The residual heat indica-

tor does not come on.

The cooking zone is not

hot because it operated

only for a short time.

If the cooking zone oper-

ated sufficiently long to be

hot, speak to the service

centre.

The Automatic Heat Up

function does not oper-

ate.

The cooking zone is hot. Let the cooking zone be-

come sufficiently cool.

The highest heat setting

is set.

The highest heat setting

has the same power as

the Automatic Heat Up

function.

The heat setting changes

between two levels.

The Power management

is activated.

Refer to “Power manage-

ment”.

The sensor fields become

hot.

The cookware is too

large or you put it too

near to the controls.

Put large cookware on the

rear cooking zones if nec-

essary.

comes on.

The Automatic Switch

Off operates.

Deactivate the appliance

and activate it again.

comes on.

The Child Safety Device

or the Lock function op-

erates.

Refer to the chapter “Daily

Use”.

comes on.

No cookware is on the

cooking zone.

Put cookware on the

cooking zone.

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire