Electrolux GK69TSIO Manuel d'utilisateur télécharger pdf (Page 12)

Problem Possible cause Remedy

There is no signal when you

touch the panel sensor fields.

The signals are deactivated. Activate the signals. Refer to

“OffSound control”.

comes on

The Automatic Switch Off oper-

ates.

Deactivate the appliance and

activate it again.

comes on

The Child Safety Device or the

Lock function operates.

Refer to the chapter “Daily

Use”.

comes on

There is no cookware on the

cooking zone.

Put cookware on the cooking

zone.

The cookware is incorrect. Use the correct cookware.

The diameter of the bottom of

the cookware is too small for

the cooking zone.

Use cookware with correct di-

mensions.

The cookware does not cover

the cross / square.

Cover the cross / square fully.

and number comes on.

There is an error in the appli-

ance.

Disconnect the appliance from

the electrical supply for some

time. Disconnect the fuse from

the electrical system of the

house. Connect it again. If

comes on again, speak to the

service centre.

comes on

There is an error in the appli-

ance because a cookware boils

dry. The overheating protection

for the cooking zones and the

Automatic Switch Off operates.

Deactivate the appliance. Re-

move the hot cookware. After

approximately 30 seconds, ac-

tivate the cooking zone again. If

the cookware was the problem,

the error message goes out of

the display, but the residual

heat indicator can stay. Let the

cookware become sufficiently

cool and refer to “Cookware for

the induction cooking zone” to

see if your cookware is com-

patible with the appliance.

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the customer service. Give the data from

the rating plate, three digit letter code for

the glass ceramic (it is in the corner of the

glass surface) and an error message that

comes on.

Make sure, you operated the appliance cor-

rectly. If not the servicing by a customer

service technician or dealer will not be free

of charge, also during the warranty period.

The instructions about the customer service

and conditions of guarantee are in the guar-

antee booklet.

INSTALLATION INSTRUCTIONS

Warning! Refer to "Safety information"

chapter.

Before the installation

Before the installation of the appliance, re-

cord the information below from the rating

plate. The rating plate is on the bottom of

the appliance casing.

• Model ...........................

• PNC .............................

• Serial number ....................

12 electrolux

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire