Electrolux U30280 35772G Manuel d'utilisateur

35772GGas hobOperating InstructionsGB

10Guarantee ConditionsStandard guarantee conditionsWe, AEG-Electrolux, undertake that if within 12 months of the date of the purchase this AEG-Electro

11Instruction for the InstallerEngineers technical dataBURNER RAPID SEMI-RAPID AUXILIARY TRIPLE(large) (medium) (small) CROWNPOSITION MAX MIN MAX MIN

12Important safety requirementsThis hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations(Current Edition) and th

13InstallationImportantThis hob must be installed by qualified personnel to the relevant British Standards.Any gas installation must be carried out by

14FO 2038Cut Out SizeThe dimensions of the cut-out are given in the diagram.Building InBuilding over a cupboard or drawerIf the hob is to be installed

15FO 2564ON/OFF SWITCHFLEXOUTLETON/OFF SWITCHFLEXOUTLET1FO 25632Building over a kitchen unit with doorProper arrangements must be taken indesigning th

16Fitting the Hob into the worktopCarry out the building in of the hob as follows:• put the sealssupplied with the hob, onthe edges of the cut out:pl

17Electrical connectionsAny electrical work required to install this hob should be carried out by a qualifiedelectrician or competent person, in accor

18Permanent ConnectionIn the case of a permanent connection, it is necessary that you install a double poleswitch between the hob and the electricity

19Fault FindingPreliminary Electrical Systems CheckSTARTIsolate applianceand carry out:A: Earth Continuitycheck. Has inlet fuse blown?Carry out:C: Pol

2 Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. Ifyou need assistance, contact our Customer C

20A. EARTH CONTINUITY CHECKAppliance must be electrically disconnected - meter set on Ω (Ohms) x 1 scale andadjust zero if necessary.— Test leads fro

21Check gas supply atburnerIgnition System / Gas IgnitionYESCheck plug top fuse andreplace if necessaryCheck polarity and earthcontinuity of supply po

22CommissioningWhen the hob has been fully installed it will be necessary to checkthe minimum flame setting. To do this, follow the procedure below.-

23Conversion from Natural Gas to LPGIMPORTANTThe replacement/conversion of the gas hob should only be undertaken by acompetent person.It is important

35678-7203 03/05Grafiche MDM - Forlì From the Electrolux Group. The world’s No.1 choice.The Electr

3 Ensure the control knobs are in the ‘OFF’ position when not in use. When using other electrical appliances, ensure the cable does not come into co

4ContentsGuide to Use the instructionsThe following symbols will be found in the text to guide you throughout the Instructions:Safety InstructionsSt

5Description of the HobInstallationFig. 1Any gas installation must be carried out by a registered CORGI installer, and inaccordance with existing rule

6Burner minimum maximumdiameter diameterTriple-crown (ultra-rapid) 160 mm 260 mmLarge (rapid) 160 mm 240 mmMedium (semi-rapid) 120 mm 220 mmSmall (aux

7Before any maintenance or cleaning can be carried out, you must DISCONNECT thehob from the electricity supply.The hob is best cleaned whilst it is st

8Something Not Working?If the hob is not working correctly, please carry out the following checks before contactingyour local Service Force Centre.

9Service and Spare PartsCustomer CareWhen you contact the Service Centre, they will need the following information:1. Your name, address and post code