Electrolux CONTROLBOX 24/7 Manuel d'utilisateur télécharger pdf (Page 8)

PROGRAMMING

All commands to the unit must be given in capital letters. It is therefore important that you use CAPITALS when sending

commands to the unit. Formulate commands to the unit as follows:

Examples of all commands are given later in this manual.

The unit will always acknowledge a successful command with “Conﬁrmed: <STATED COMMAND STRING>” so that you know

that the command has been correctly given and executed.

If an incorrect command is sent to the unit, it will automatically forward the message to the primary reporting number

(TEL1) with the following preﬁx: “Unknown command”.

To enable the unit to know which status reports to send, one or more numbers must be entered. Up to 5 different

numbers can be entered for receiving status reports.

To save a number as the unit's primary reporting number (TEL1) send the following text message to ControlBox24/7;

TEL1 <NUMBER> Example: TEL1 070765874

To enter more report recipients, replace TEL1 with TEL2, TEL3, TEL4 or TEL5.

To delete a registered report number, replace the telephone number with DEL as follows:

TELx DEL Example: TEL2 DEL

The primary reporting number TEL1 differs from the others as follows: if an unknown or

incorrect command is sent to to the unit, it will be automatically forwarded to the number

saved as TEL1.

TIP! If you send TEL? to

ControlBox24/7, you will

receive a list of all telephone

numbers stored in return.

Enter reporting number

Formatting programming strings

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 203 204

Pas de commentaire

Electrolux CONTROLBOX 24/7 Manuel d'utilisateur Page 8