Electrolux END32320X Manuel d'utilisateur télécharger pdf (Page 15)

electrolux 15

Positioning

Position your appliance wherever possible

as far away from heat sources as possible

(heating appliances, cookers or bright

sunlight). It should be installed at least 50 cm

away from radiators, gas or coal cookers,

and 5 cm away from electric ovens.

Level the appliance correctly by adjusting its

feet, so that it tilts slightly backwards to make

it easier to shut the doors.

The space underneath the appliance should

remain free to allow the air to circulate. Do

not cover it with a mat, etc.

Make sure that air can circulate freely all

around the appliance by keeping a clearance

of at least 30 mm on either side and of 50

mm behind it. If however you wish to position

the appliance in a recess or directly beneath a

cabinet, it is vital that you leave a clearance of

90 mm between the top of the appliance and

the cabinet above it.

Make sure you observe a minimum clearance

of 10 cm between the side of the appliance,

where the hinges are, and the wall to allow

the shelves to be removed when the door is

open.

If the appliance is installed beside

another refrigerator or freezer, observe a

minimum clearance of 2 cm to prevent any

condensation from forming.

To ensure your appliance operates

correctly, the ambient temperature of

the room in which it is installed must

be between +18°C and +38°C. Outside

this temperature range, its performance

levels may drop.

The appliance must be unpluggable at

all times; it is therefore necessary for the

wall socket to remain accessible once

installation is complete.

On commissioning

Clean the interior with warm water and

odourless detergent (washing-up liquid)

before using the appliance. Rinse and dry

thoroughly.

If you unplug or turn off the appliance, wait

at least 10 minutes before plugging it back in

or turning it back on to avoid damaging the

compressor.

Electrical connection

Your appliance should only be plugged into

a 230 V single-phase socket. Make sure

your electricity meter can provide the power

absorbed by your appliance taking into account

the other appliances already plugged in.

Rating of the linear fuses (one per phase)

10 A at 230 V.

Important

The appliance must be installed

according to good practice and in

compliance with the provisions of

standard NFC15100 and with the

instructions provided by your local

electricity provider.

Use an electricity socket with an earth

terminal, which must be connected

in compliance with the provisions

of standard NFC15100 and with the

instructions provided by your local

electricity provider; this electricity socket

must be accessible at all times.

If the power supply cable has been

damaged, it must be replaced with a

certiﬁed power supply cable.

This task should only be performed by a

qualiﬁed professional, by your retailer, or

by the appliance manufacturer.

The appliance must not be connected to the

electricity supply via an extension lead or

multiple plug.

Make sure the earth connection conforms to

the applicable regulations in force.

The manufacturer shall not be held liable

in the event of personal injury or property

damage caused by non-existent or faulty

earthing.

Installation

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Commentaires sur ces manuels

Pas de commentaire