Electrolux EKG64100OX Manuel d'utilisateur télécharger pdf (Page 27)

D

F

E

3.

Carefully move the burner off the in-

jector support (D).

Slowly move it to the left side. Make

sure that the burner bush stays on

the burner mouthpiece. Do not apply

force to the wire of the spark plug

connector (E) and to the thermocou-

ple conductor (F).

4.

Release the burner injector (D) with a

7 mm socket spanner and remove it.

Replace it with the necessary one.

5.

Assemble the burner in the opposite

sequence.

6.

Replace the gas type sticker near the

gas supply ramp with the one related

to the new gas type.

Minimum level adjustment of the oven

burner:

1.

Remove the knob for the oven func-

tions.

2.

Adjust the by-pass adjustment screw

(A) with a thin-bladed screwdriver.

A

Change of the

type of gas

Adjustment of

the adjust-

ment screw

From natural

gas to liquid

gas

Fully tighten the

adjustment

screw in.

Change of the

type of gas

Adjustment of

the adjust-

ment screw

From liquid gas

to natural gas

Release the ad-

justment screw

approximately

3/4 of a turn.

3.

Attach the knob for the oven func-

tions.

4.

Light the oven burner. Refer to the

section "Gas oven cooking: Ignition of

the oven gas burner".

5.

Turn the knob for the oven functions

to the maximum position and let the

oven heat for 10 minutes.

6.

Turn the knob for the oven functions

from the maximum to the minimum

position.

Control the flame. If the flame goes out,

do the procedure from point 1 to point 6

again. There must be a small regular

flame on the oven burner crown.

The manufacturer declines liability if

you do not obey these safety meas-

ures.

ENGLISH 27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire