Electrolux EBSL6CN Manuel d'utilisateur télécharger pdf (Page 20)

11.1 Catalytic cleaning

The walls with a catalytic coating are self-

cleaning. They absorb fat which collects

on walls while the appliance operates.

1.

Remove all parts from the appliance.

The catalytic cleaning

procedure cannot start:

– If you do not remove the shelf

support or telescopic shelf run-

ners (if present).

– If you do not fully close the

door.

2.

Activate the Catalysis function in the

main menu.

3.

Press OK to confirm.

The display shows the time of day

and duration of the cleaning process

(1 hour). You cannot change the du-

ration, but you can use the End Time

function to delay the start of the

cleaning process.

4.

An acoustic signal sounds after the

time ends. The appliance deactivates.

5.

Touch a sensor field to stop the sig-

nal.

6.

Wipe the bottom of the appliance with

a soft and moist sponge.

• When the appliance is at the set tem-

perature, the door locks.

• During catalytic cleaning the lamp is on.

• Spots or discolouration of the catalytic

surface have no effect on the catalytic

properties.

11.2 Shelf supports

Removing the shelf supports

You can remove the shelf supports to

clean the side walls.

1.

Pull the front of the shelf support

away from the side wall.

1

2

2.

Pull the rear end of the shelf support

away from the side wall and remove

it.

Installing the shelf supports

Install the shelf supports in the opposite

sequence.

11.3 Removing / inserting the

door

To clean the door remove it.

20

www.electrolux.com

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire