Electrolux EHP333X Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 10
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
Pilot light
Pilot light is activated when either of
the zones are turned on, and will
remain on until the cooking zones are
switched off.
Residual-Heat indicator
Each plate has a residual heat
indicator which remains on as long as
the temperature of the cooking zone
exceeds 80˚C, even if the cooking zone
is switched off.
This table should be used as a guide only. The settings
depend on the saucepan you use, quantity and contents. After
a while you will learn to choose the correct settings. See also
the section “Advice and hints for using the cooking zones”.
Settings for ordinary cooking zones
Step Function
0 The cooking zone is switched off
1 - 2 Keeping warm
3 - 4 Gentle boiling - small portions
5 - 6 Gentle boiling - big portions
7 - 8 Frying
9 - 10 -11 Frying / browning
12 Bringing to the boil / quick frying / deep-
frying
14
It is not necessary to attach the
reinforcement beam to the work top
surface, as it is held in place by a
specially designed moulding, which is
incorporated in the hob units flanges.
The units externally measured
length
145 mm:
Cooker hood
290 mm:
Two-zone ceramic-top electric hob
Two-burner gas hob
Grill
Wok
580 mm:
Four-zone ceramic-top electric hob
Four-burner gas hob
725 mm:
Four-zone ceramic-top electric hob
Installation of a single unit
When mounting a single unit, be it a
half-or full size unit, in a
worktopsurface which is thicker than
30 mm, it is necessary to make a
special notch in both sides of the cut-
out hole, as shown in the adjacent
drawing.
The purpose of these notches is to
create space for the electrical cables.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire