Electrolux EHP333X Manuel d'utilisateur télécharger pdf (Page 8)

8

Advice and hints for using the

cooking zones

If you use the advice below

you will save energy and

make your cleaning tasks

easier.

Adjust the cooking zones

correctly.

Select the highest setting

for the cooking zones until the food is

brought to the boil. Then reduce the

setting as far as possible, without the

food going off the boil.

Use level saucepans. An

uneven saucepan may

increase the electricity

consumption by up to 50 per

cent. Check whether your

saucepans have level bases

by placing the item in question

upside down on a work top and

positioning a ruler on the base.

A curved base, both inwards and

outwards, will prolong the

cooking time and increase the

energy consumption

The saucepan should match

the cooking zone – or be

slightly larger. Remember

that a large saucepan can also

hold small quantities. If the

diameter of the base is too small,

the energy consumption will

increase, and any food boiling

over will burn onto the hot

cooking zone.

Saucepans with very

shiny/bright bases will

prolong the cooking time

slightly compared with

cooking utensils with

matt/dark bases.

Use a tightly fitting lid on the

saucepan. Without a lid you

use more than three times as

much electricity.

13

Minimum distance

to side wall:

150 mm

Minimum distance

to back wall (non-

flammable material):

50 mm

Reinforcement

beams

Mounting

Caution: In order to avoid a hazard this

appliance must be installed according to

these instructions for installation

The appliance unit can be mounted in

any type of kitchen with a work top

whose thickness is between 28 mm and

40 mm.

Clearance

The distance between the top side of the

work top and the carpentry underneath

must be at least 47 mm.

Fixing

Screw the fixing brackets out to such an

extent that they can be turned in under

the work top. Tighten the brackets on to

the work top with an ordinary

screwdriver.

Cut-out measurements

One rectangular hole is sawn out for the

appliance combination chosen.

The depth of the cut-out for any unit is:

490 mm

Length of hole = sum of all units`

externally measured length, less 20 mm.

Mounting of Reinforcement

Beams

A reinforcement Beam, with supporting

flanges at each end, is included with

each two-burner unit. For unit

combinations, a reinforcement beam

must be used between each unit.

Min. 47 mm

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire