Electrolux EKK6450AOX Manuel d'utilisateur télécharger pdf (Page 32)

4. Replace injectors with the ones

necessary for the type of gas you

use.

5. To change to gas G110, G120 or

G2.350, attach the air regulator onto

the main jets. Screw it on as tight as

possible.

6. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply.

You can find this plate in

the bag supplied with the

appliance.

If the supply gas pressure is not constant

or it is different from the necessary

pressure, install an applicable pressure

adjuster on the gas supply pipe.

13.13 Adjustment of minimum

level at the hob burner

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

by-pass screw position (A). The

bypass screw position (A) depends

on model.

A

• If you change from natural gas to

liquid gas, fully tighten the

adjustment screw.

• If you change from liquid gas to

natural gas, undo the by-pass

screw approximately 1/4 of a

turn .

WARNING!

Make sure the flame does

not go out when you quickly

turn the knob from the

maximum position to the

minimum position.

13.14 Levelling of the appliance

Use small feet on the bottom of

appliance to set the appliance top

surface level with other surfaces.

www.electrolux.com32

1 2 ... 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire